Installation and operation manual for inflatable air dancer

1. Setup

The inflatable air dancer can be installed on any type of surface.

2. Power connection

Inside the figure there are two plugs:

• one for the blower,
• one for the lighting.

You need to:

1. Connect both plugs to an extension cord.
2. Pull the socket of the extension cord inside the figure to protect it from rain.
3. Close the zipper.
4. Plug the extension cord into a 220 V outlet.

After activation, the figure will inflate automatically.

3. During operation

Once the air dancer is upright, it must be secured with ropes. There are four attachment loops on the figure. You may tie the ropes to:

• a tree,
• a fence,
• a pole,
• a weight,
• a ground anchor,
• any stable object.

The goal is to prevent swaying during gusts of wind.

4. Movable arm

The arm attaches with Velcro and wears out over time - this is normal. The set includes one installed arm and three spare arms. Alignment marks indicate the center and help position the arm correctly.

Additional information

Weather resistance

The figure can operate in rain, snow and in any temperature. It does not need to be moved or stored. Exception: wind gusts from 15 m/s. In such cases, switch the figure off and bring it indoors.

Blower maintenance

Once a month, check the blower for leaves, debris or dust. Clean if necessary. Blower lifespan is about 10,000 hours. If the bearing wears out, it can be replaced.

Replacing the sleeve

1. Disconnect the figure from power.
2. Unscrew the fan grill from below.
3. Unscrew the blower from the base.
4. Remove the old sleeve.
5. Install the new sleeve onto the base.
6. Insert the blower into the new sleeve and fasten it.
7. Reattach the fan grill.

The figure is ready for operation.